ALL NORCOSTCO OFFICES WILL BE CLOSED 12/23-12/27. ANY ORDERS PLACED DURING THIS TIME WILL BE PROCESSED THE FOLLOWING WEEK.
PRO MAKEUP ARTISTS: PLEASE USE THE NEW PROMAKEUP.COM TO RECEIVE YOUR DISCOUNT ONLINE!
Any Items listed at reduced pricing is only valid online not in store
Latex Mask Making has just been elevated to another level.
Introducing Ed and Alanna H2.0, the world's first water fillable sculpting busts from The Monster Makers. Completely reengineered and reimagined, Ed and Alanna H2.0 are composed of a special, high-density plastic that can withstand the rigors of mold making and years of continued use with little to no wear. Not only are Ed and Alanna endlessly reusable, but Mold Making has never been easier. Simply sculpt your character over the form and make your mold, and here is where the magic comes into play:
RAD (Radiant Assisted Demold) Technology™ provides an easy, built in clay release system which dramatically aides in the demolding process for artists and mask makers using wax based clay mediums. Each RAD enhanced headform becomes, in effect, a hot water vessel which efficiently transfers radiant heat from inside the form to the surrounding clay causing a softening effect within the mold. Molds made over RAD enhanced forms can be demolded rapidly and without difficulty, resulting in a greatly improved mold-making experience. When you are ready to demold, simply turn the mold over with the bottom side up, unscrew the included inset bottle cap and fill the head form with hot water. Within minutes, radiant heat will begin to penetrate the clay and into the mold for the easiest demolding experience you've ever had. Say goodbye to broken or stuck head forms! INSIDER TIP: Need to weigh down your armature but still want to utilize the RAD functionality? Fill it full of sand!
The Ed Head measures 18" H x 13" W x 11" D with a circumference at the brow of 23" approximately.
The Alanna Head measures 17” H x 12” W x 9.5” D with a circumference at the brow of 22” approximately.
Each headform is supplied with a black plastic cap to seal the bottom spout.
Approximate Additional Measurements
Width of face | 5 ½” |
Outer corner of eye to Outer corner of eye | 4 ½” |
Outer corner of eye to Outer edge of ear | 4 ½” |
Bridge of nose to Tip of nose | 2” |
Edge of nostril to Tip of nose | 1 â…–” |
Philtrum (Bottom of nose to Top of upper lip) | â…—” |
Jaw profile (Tip of chin to neck) | 3” |
Bottom of earlobe to Tip of chin | 5 ½” |
Length of face (Top of head to bottom of chin) | 9” |
Top of browbone to Bottom of eye socket | 2” |
Bottom of eye socket to Bottom tip of chin | 3 ¾” |
Outer edge of nostril to Outer edge of nostril | 1 ¾” |
Width of mouth | 3” |
Bottom of lower lip to Bottom tip of chin | 1” |
Width of chin | 2” |